
Pipeline coating removal by induction
Evaluate induction stripping for heavy external coatings on steel pipelines. Check pipe geometry, coating layers, operator requirements and recoating prep.
Assess the pipe and its external coating together
An induction tool heats the steel pipe wall locally to loosen the external coating for mechanical removal and collection. For corrosion protection renewal, the factors that determine feasibility include pipe outside diameter, wall thickness, coating layers, tool clearance and the temperature limits set by the pipeline operator. A representative test helps evaluate coating release and the condition of the exposed steel before selecting a removal method.
Review the CR2100 induction system
Where it fits
External pipe coatings
Consider pipe sections with heavy external coatings that have to be replaced or inspected.
Corrosion protection renewal
Plan the surface preparation for the protection system that will be applied afterwards.
Pipeline refurbishment
Compare the removal route before committing to a large pipe run.
From coated pipe to a prepared surface
Identify the coating system
Record the pipe outside diameter and wall thickness, coating type and thickness, and the operator’s temperature limits.
Agree the site conditions
Confirm the working space, the power and cooling arrangement, the ventilation and the approval of the pipeline operator.
Strip and inspect
Loosen the coating in sections, collect the debris and inspect the pipe surface before any protection is applied.
What controls the process?
- Pipe diameter and curvature
- Smaller diameters have tighter curvature. Check inductor fit and clearance around the pipe, particularly at bends and other restricted points.
- Coating layer structure
- Bitumen, rubber and polyolefin layers react differently to heat.
- Pipeline safety approval
- Heating on a pipeline that carries product under pressure is only carried out with the operator's approval.
Induction system for pipeline coating removal
Can induction heating be used on a pipeline under pressure?
Not without the approval of the pipeline operator and a review of the temperature limit of the whole system. Heat on a line under pressure is a decision that belongs to the operator.
What happens to the coating once it is loosened?
It still has to be scraped off, collected and removed from site. Induction heating removes the bond, not the material.

